BimmerFest BMW Forum banner
cam shaft
1-8 of 9 Results
  1. E39 (1997 - 2003)
    Hello, I've read on the subject but just wanted to get some input from the board members on this. I recently just changed my battery as the car was giving me signs of a bad battery Now though, the car has stalled on me twice within a three week period either at really low speeds, or at a stop...
  2. X5 E53 (1999 - 2006)
    Hello, I have a BMW 2000 X5 4.4 in which I have to install a new Vanos, of which I now need the tools to do this job. They are very expensive and I only need to use them once. Does anyone have these tools they'd be willing to rent to me for my use and then return them to you? I appreciate...
  3. E46 (1999 - 2006)
    Hey guys. I am new here so go easy. I got a hold of a 2001 318I SE 1.9 and the car was running good for around 1000 miles. It was recently serviced and MOT'd but i always take those things with a pinch of salt. after the 1000 mile mark i noticed the car would have trouble starting up on a...
  4. E36 (1991 - 1999)
    i was wondering if there were any camshafts for a 1995 318i sedan i dont want to motor swap or anything if any of has any custom ideas let me know also want to boost it around 10 or maybe 18 after lowering compression
  5. 7 Series - E65 / E66 (2002 - 2008)
    Hello. I was replacing the camshaft sensor in bank 2 on my 2003 BMW 745li, because I just got the code for it. Replacing the sensor did not help the issue and check engine is still on. After that I decided to take out and clean both VANOS solenoid valves. After I put them back in, the car...
  6. E34 (1989 - 1995)
    hi all hope your day is better than mine, i could use some help. i just replaced the head in my 1992 525 is it possible that i have it 180 degs off? i installed the head with the piston at tdc (# 1 ) and used the cam lock tool the writing on the cams was facing up with the two marks facing...
  7. E46 (1999 - 2006)
    please bear with me while i explain my story. ok, so about a year ago my lovely 330ci started to misfire and during idle the rpm needle would constantly move up and down until the car would eventually shut-off. so i took it to a local bmw shop and had a diagnostic on it and they came back with...
  8. E39 (1997 - 2003)
    so i took my 528i today to get the camshaft sensor changed because that was the code i was getting on the scanner. when i went to go pick it up i thought it was going to be all fixed but it seemed that the problem got worse after changing the camshaft. they changed to intake camshaft but not the...
1-8 of 9 Results
Top