BimmerFest BMW Forum banner
crank sensor
1-11 of 11 Results
  1. E39 (1997 - 2003)
    i have a 523i 1997, non TU M52, with 110k miles i noticed sometimes at around 4000 rpm to like 5000 it hesitates, loses power, and then suddenly at 5500 it has a burst of power all the way to 6500, and also when i start it after sitting a while, it cranks quite a bit, cold starts are fine, but...
  2. E30 (1982 - 1993)
    Whats up guys? I’m having fuel issues with my 89 BMW 325i Sedan. I bought the car in running and operation condition 1 month ago. Car started with no trouble. However since then, car hasn’t started. The car still cranks, however it doesn’t start. Things I have done to the car: Installed a brand...
  3. E46 (1999 - 2006)
    My 2001 bmw 325i that has a slapshift transmission in it and the m54 motor in it. Has a new fuel pump, spark plugs coil pack boots, coil packs are good compression is all good new fuel filter battery and transmission. First start of the morning the car idles like crap and shakes and knocks in...
  4. E39 (1997 - 2003)
    So.....I have a 2000 528i, E39, 180K miles, and My mechanic said yesterday I have a leaking fuel injector on cylinder 6. He Wasn't specific about the leak, not sure if its O-ring, the body of the injector or the top or bottom of it is leaking. (YES, I should have asked, but pretty upset with the...
  5. E90/E91/E92/E93 (2006 - 2013)
    Have a 2008 328i, A/T. Just replaced the valve cover assembly because it had an internal leak. Soon after the engine randomly shuts off. mostly at idle. It feels like ignition not fuel. I literally just turns off. Engine will restart. A few minutes later it will shut off again. the CEL is not...
  6. E30 (1982 - 1993)
    So This may be a dumb question but do e30's have a cam position sensor? I know they have a crank position sensor (CPS) which is right by the ac pulley and I have replaced, but I am wondering if there is a Cam sensor that may need replacing. I've read up the symptoms and it seems like I have some...
  7. E36 (1991 - 1999)
    Hi! I have a E36 318is from 1991. Im ordering a EMS, and was asked if my engine have a 60-2 crank encoder wheel? As I can understand the m42 have a crank trigger and camshaft sensor? Enlighten me please :) Thanks from Denmark!
  8. E36 (1991 - 1999)
    93 325I E36, Throws a misfire code for cylinder 2 and 5. I checked coil packs, plugs, wires, fixed acouple vacuum leaks and changed a valve cover gasket. Also throwing a code for the crank sensor..:tsk: Car has a rough idle when started, when going through the RPMs theres severe hesitation and...
  9. E36 (1991 - 1999)
    I have a 1993 325i E36, i checked coil packs, plugs, and fixed acouple vacuum leaks.. The car idles rough and has a severe lack in power between 2500-3500rpm. After it reaches 3500rpms the car seems to hit the power band and pull strong until about 5500 and then the car skips out and the check...
  10. E34 (1989 - 1995)
    My 1995 525i is running rough all the sudden. I tested with a Peake 5 tester, and it came up code "10". According to the chart, that is the Crank Sensor. The car runs rough at idle, and sputters a bit while pushing gas. As RPM picks up, the sputter disapates, but is still present. It runs like...
  11. E39 (1997 - 2003)
    Ok guys I've got a serious tech question! I have a 1997 528i it blew a head gasket right after I bought it. Since the car had almost 200k on it I chose to replace the motor rather than just fixing the head gasket. I scored a motor with 65k for $1000 shipped to my door. Once we started stripping...
1-11 of 11 Results
Top