Search Results for ‘ecu’

I had this car sitting for a while now and i want to give it a ride but it doesn't start the engine it's all ok it has spark/air/fuel/and its timing is ok also, I have bought a new battery, on the dashboard it shows 12.5 volts so it's strong but the main concern is that the ECU was fried and i...

Transmission problem? I started up my X5 a bout a week ago and I received the following messages on the screen DSC / AWD warning comes up immediately.. and the shifter clicks in and out of park (by that i mean the "P" light goes in and out .. it doesn't go into gear or neutral) it will not allow...

I have my 2006 e90 325i in the shop right now, reason being is the traction control light on and no cruise control. Tech guy said that the DME is seeing an automatic transmission, it was built from South Africa as a manual six speed. Checked with the VIN number and it is a manual six speed...

Hi all This morning car would not start only a 2006 320d. Everything seemed to be on as should be but starter not even trying to turn over so thought starter. Got lift to work... came home and checked fuses all ok so tried starting again this time turned over but does not fire so tried again and...

.

I recently bought a 2014 BMW 328i that doesn't recognize its key anymore. I opted to buying a used set of ECU, immobilizer, and key that were pulled from the same car because the original immobilizer was presumably damaged, and so that I don't have to go through the hassle of programming a new...

Hey everyone, Haven't gotten anywhere with this and need help. About 2 days ago I got in and started my car and the whole dashboard lit up and power steering went out. I have ABS, DTC, CEL, brake light, passenger air bag, and a drivetrain malfunction. Before this happened I had no check engine...

Hi. I'm getting the codes p0600 serial communication link, p0031 HO2S heater control circuit low bank 1 sensor 1 p0051 HO2S heater control circuit low bank 2 sensor 1 and my transmission is currently in limp mode every time i start the car. i was wondering if anybody can confirm that faulty...

So I am new to flashing modules and have done basic coding, but I am just completely lost right now and help would be much appreciated as its hold back from doing a motor in my daily and its cost me everyday I don't drive it. Well my uncle let a had a mechanic do a valve cover gasket change on...

My alternator started screeching badly over a period of 3 weeks. The vehicle would not start a few days ago (potentially parasitic drain from the rectifier). I was mindless enough to initially partially detach the positive on the alternator while the battery was still attached (3am in the...

Hello BMW enthusiasts! Im experiencing another bmw fault, so it started happening after i installed COBB stage 1 sport map,gained noticeable power and then under power injection coil cyl 4 stopped working.Replaced that and it was no issues. I was like ok lets install stage 1 aggressive mode...

There is absolutely no difference in measured air flow in INPA when i connect and disconnect the MAF sensor, even went as far as testing the MAF being connected, but the whole sensor being taken OUT of the intake tube, which in my opinion should make the car go crazy - absolutely NO difference...

My Vehicle: 2005 E60 545i w/ CCC Unit (N62 Engine) Hello, I was coding my CAS and LMA module for my new battery (Went from a 90Ah AGM to a 100Ah Lead Acid but coded it for 90Ah as to not keep overcharging the batter. Not sure if that logic is flawed.) via NCSExpert. It coded successfully. Then...

I just picked up a 2004 325ci with a blown head gasket, other than that, it's a beautiful car and I plan to keep it. I also have a 2001 330i which is not much more than a parts car but it has a strong motor, good compression, low miles, an ideal motor for a swap. Oh, and both are automatics. I'm...

x5 40e with 18,000 miles, 2017 model just out of warranty. Loved the machine but now I regret keeping. The electric drive system stopped working, battery is fully charged, no check light, no scanned errors. eboost is working. Occasionally is turns normal Has this happened to any one of you...

Hi, is it possible to flash the 340i Ecu to "Performance Software"? Esys & I-COM & other tools where present. greetings

Good afternoon, first of all apologies if this question has been answered before but I have not found it in the forum. I am being using ISTA-D for diagnostic and basic maintenance (e.g. reset adaptation values) with ENET cable without issues, also E-SYS for FDL coding. That said, I am...

Hi, sorry for my English, I try my best to express the problem understandable. I replaced a PDC ECU in a 118i E87 from 2006 (May). There was water in the box for the ECUs. So we disconnected the ECU for comfort access to dry everything. Now, the comfort access (passive go) is not working any...

Hi, Alarm went off when I went off on holiday. Deaded the battery completely. No glimmer of lights on dash for a day or so. Managed to jump start it. Now it smokes on acceleration. Have i upset the coding or damaged a module? It tick over and starts well and is a very well maintained engine...

Hello All, I recently had my car at a local dealership. I had some fluid changes and asked to have the ECU modules updated, to make sure they were at the latest revision. The Service Advisor had no idea what I was talking about. Is there anyone in the Milwaukee area that can apply the latest...