Search Results for ‘engine block’

Howdy :) I had a reconditioned Euro, B35 head that I had no use for so I traded it for a complete engine that is supposed to be an M30B34 (535). 3.5 is cast into the side of the block, the intake manifold looks correct and has the expected 3.2/3.5 on the casting, but when I checked the VIN...

:cry: Well I need to find a used engine for my Roadster 1.9L and trying not to exceed the value of the car, blew a head gasket. anybody got any ideas? I live in California.

Hi, I bought a 2009 BMW 530i with the N53 engine, the car was running badly and my mechanic fully dissembled the engine to find that the engine block was cracked. Searching on websites I can't find an N53 engine block but I can find plenty of N52 engine blocks at decent prices, so my question...

Amazing Deal if anyone is in the market $6507.95 down to $2462.23 Genuine BMW Engine Block With Piston - 11112296653 - E70 X5,E71 X6 Link to Item:https://www.turnermotorsport.com/Cart/?add1=180540&qty1=1&utm_source=ishea&utm_medium=email&utm_content=link2cart&salesrep=ishea

Hi everyone, I'm looking for some serious advise, help and direction here. Back in May I had the serpentine belt, tensioner and idler pulleys replaced on my 2008 e92 335i. When the upper idler pulley was being replaced it was over tighten and stripped the threads of the aluminum block. The hole...

Will a 98 or 99 318i exhaust manifold fit a 95 318i manifold? I have seen that some old 95 EM fit 96-99 cars, just wondering if the 97-99 fits the 95's. I found a pick a part that have 2 318i's but they are a 98 and 99 years and the tubing looks different from my manifold from what I have seen...

Hey everyone, so this is the story, I badly need some advice. My 120K 325i is starting to flash the oil pressure warning light and after replacing the oil pressure switch and some limited further inspections I can safely assume that I need an engine rebuild due to worn out bearings and/or other...

I just bought my first Beamer from an auction in Los Angeles. She's a 1997 3.18i 4 Door Sedan (automatic), runs decent but i've noticed that when im driving up hill (stop & go) that i there is a shutter that makes the car rattle (sometimes more than once in a single acceleration). The...

I have a 2000 740il. The engine run but recently service engine light came on. The code is timing issue and the engine has a knock. My guess from reading other threads is that the time tensioner has failed causing internal issue in the engine. I have looked for a used engine but not able to find...

While installing a new water pump on my 97 540i, the long 4" bolt broke. This left a 1/2 stud deep in the engine block. Anyone suggestions on how this can be removed? Will an ez-out fit that deep in the block? I was also wondering if I can just install a plug and use a smaller stud? Any...

Well, I've had no coolant issues in a while & have been changing the coolant annually to help insure there would be no more. Then lo & behold the check coolant level lamp finally came on again:(. I ordered a fitting for my pressure tester to fit the expansion chamber on my 540i & tested it once...