BimmerFest BMW Forum banner
ethernet

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Car Navigation, Audio & Electronics
    Hello, I've just purchased a new BMW 530e 2020. G30 5-series built after 07/2019 use the new iDrive 7, which uses a MGU head unit (instead of NBT-EVO), RAM+Booster amplifier (instead of ASD and AMP) and TCB2 (instead of ATM). MGU connects to RAM using an OABR ethernet bus, instead of the MOST...
  2. BMW Coding and Programming
    Hello :D I'm trying to understand some stuff, so this is going down as a R&D topic. I've got a HU_Entry (2014) off a F10, I want to read and edit the FDL via esys using the Quadlock Eth connection. The issue is that my headunit is sending ARP frames (Wireshark logs) and I can see it's IP, but...
  3. BMW Coding and Programming
    While coding my F48 I fired up WireShark (packet sniffer) after I connected the OBD/Ethernet Cable to my laptop and noticed that two MAC Addresses were broadcasting DHCP Requests. It appears that there is a built in ethernet switch inside the vehicle, with at least 3 ports, one for each MAC and...
  4. BMW Coding and Programming
    Does anyone know if it is possible to gain access to an F-Series' CANbus using an OBD2 to Ethernet cable? If so, could you explain the process/tools used. Specifically, I am trying to monitor the CAN messages using Wireshark. When I capture my ethernet connection currently, I am seeing some...
  5. BMW i3 I01 (2014 - 2020)
    Hello, I have the OBD ethernet cable used for coding my i3. I'd like to read OBD the error codes using the same cable. Is this possible,, if so, which software will work with this cable?
1-5 of 5 Results
Top