BimmerFest BMW Forum banner
head gasket change

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. E36/7 Z3 (1996-2002)
    Hello, I came into possession of a 1998 Z3 1.9 with the M44 engine. It had major oil leaks and ran kind of sluggish. I decided to replace the gasket on the oil filter housing and replaced the head gasket. As I was working my way back putting it together I replaced most of the seals and gaskets...
  2. E60 / E61 (2004 - 2010)
    I need major help please, i am replacing my head gasket but i need to know the torque wrench and torque specs. timing chain etc... basically there is no help on youtube so can someone help me step by step.:cry::cry:
  3. E39 (1997 - 2003)
    Anyone in Houston TX that has done a head gasket and wants to do another one ? I sure could use some help on a 2110 525i I can't go back to the shop that got me and I don't know where else to go Message me Please
  4. X5 E53 (1999 - 2006)
    Dear all I had a blown head gasket on the driver side bank of my 2005 4.4i. It was still moving and I drove it to a technician with more than 20yrs BMW experience. It was driving fine except for the morning steam blowing out of the driver's side exhaust outlet. Both heads were taken out and...
  5. E28 (1982 - 1988)
    Hello, After recently servicing my 1986 BMW E28 520i Lux I now have low compression on all cylinders. All around 4.5bar/65psi :cry: This was tested hot and only a minor increase when doing a wet test (small amount of oil on the top of each piston) During the service I have done the...
1-5 of 5 Results
Top