BimmerFest BMW Forum banner
hub
1-7 of 7 Results
  1. E46 (1999 - 2006)
    This may be a silly question but do 325i wheel bearing/hubs work with 325xi? I want to replace the hub/bearing as one piece as that is how the Haynes manual recommends doing it. I also have about 0.007" run out from the wheel hub/bearing which is why I want to replace the hub and bearing in case...
  2. E60 / E61 (2004 - 2010)
    i have a 2009 535 with Xdrive and am looking to put on some aftermaket m6 wheels and do a staggered setup. the stock tires on there now are 225/50R17 the wheels i want are 18's the tire size i want with the same rolling diameter are 245/40R18 in the front and 275/35R18 on the back. i want to...
  3. E90/E91/E92/E93 (2006 - 2013)
    Alright, so I understand there's other posts on this topic, but I've tried them and they aren't working. I'm removing the rear right hub on a 2006 325xi and everything is disconnected, except for the driveshaft. For some reason it's stuck in the hub and I was wondering if there's anything I can...
  4. E60 / E61 (2004 - 2010)
    Ok heres the scoop.... The tie rod on the passenger side was getting worn, replaced both at once with new. Alignment done. Shortly after, the passenger bearing was just grinding. How I troubleshoot it was Drive on highway, turn right grind is gone. Turn Left the grind is louder. Got new...
  5. E90/E91/E92/E93 (2006 - 2013)
    Hi does anyone have the torque specs for the four bolts the hold the front wheel hub assembly on for a 09 328i sedan.
  6. E90/E91/E92/E93 (2006 - 2013)
    Hello Everyone, looking for a little help here: My car info: 2006 325i 125K km's I recently upgraded my stock 16" rims (not staggared fitment) to 18" Klasse with Michelin ZP (zero pressure (run flat))Tyres. First I noticed a slight wobble (more of a wobble than shake or vibrate) between...
  7. E30 (1982 - 1993)
    Hi everyone. I have a 1988 325ix. With a great deal of effort, I got the left rear wheel bearing off and a new one installed. The Hub gave me grief. I may have made a mistake. I used a hammer and bearing driver to put the hub back into the bearing after I got the bearing in. (the threaded...
1-7 of 7 Results
Top