My 2005 X5 (E53) failed SMOG test recently with O2 sensor not ready. Although I had a battery change, that was over 3,000 miles ago. I've performed the drive cycle four times (using various procedures found on the Internet). I'm starting to suspect bad O2 sensors. However, there's no check...
I went through the list but couldn't find my issue. I have a 2003 745i that I cannot get INPA to connect to. It starts and runs fine and I can get a cheap $20 code machine to pull fault codes and clear them through the obd2 port. For some reason though the more advanced...
I only need my air cat and o2 monitors to come back on so that I can pass echeck in Ohio. I've tried the drive cycles on the Ohio echeck website, indestructibles, and from BMW themselves. I am currently in collage and need to get the car echecked by the end of the week before I go back to school...
Hey everyone. So the M5 threw a Check Engine Light about emissions l yesterday on my way home from work. I put my Bluetooth OBDII reader in the port and the connecting lights flash and then stop immediately and I can't get any connection to the car.
I've never had this problem before. I've used...
Hello all, I just introduced myself on the main forum but have two quick model-specific topics to bring up -
1) My car is equipped with options
S639A Preparation F Mobile Phone Cpl. USACDN
S6FLA USBAudio Interface
S8SCA Telematics Access Request,Country-Spec.
I have connected my android...
I've just purchased a used 2013 X3 and the engine suddenly stops and refuses to start again for a while.
I read the codes using an OBDII reader and the codes are:
P13DF "Manufacturer Defined"
P0003 "Fuel volume regulator control circuit low"
I intend to inspect the wiring related to...
I would like to do some coding to my 328xi. I am new to coding. I have an OBDII cable that has a USB port to connect to a computer and a pinned port to connect to the OBDII outlet in the car. Can I do coding with the OBDII cable I have? If not, what kind of cable do I need?
Thanks so much...
Hey guys, I recently went jb4 with my 320i (:supdude:). Now I am hoping to use this wifi OBDII device with it to track love driving data, and hopefully access data logs and other jb4 functions.
I noticed the jb4 mobile app and after researching it for a bit, I saw that it requires additional...
For the past three weeks I have been unable to start my car. When I scan the OBDII i get the following error codes:
P110D - Throttle Position Sensor 'A' and 'B' Range / Performance
P1631 - Throttle Valve Actuator Spring Test
P1637 - Throttle Valve Position Control, Control Deviation...
My 2002 530iA has the following problem:
When my mechanic try to get error codes list from the gearbox it did not connect. The symptom is that he couldn't communicate with the diagnostic tool to the transmission control unit. I attached screen shot of the diagnostics..
Can anyone give me...
I have this ELM327 from EBay http://www.ebay.com/itm/291261648793?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
I also have this headunit.
I have the Torque Pro App, and I'm...
Five-digit error code
P - is for powertrain codes
B - is for body codes
C - is for chassis codes
The second position:
0 - the total for the OBD-II code
1 - manufacturer code
The third position - the type of fault...
This thread is opened because ... I don't understand why I can't set the secondary air monitors.
After replacing some vacuum hoses and clearing P1083/P1085 codes & a pending P0171 lean condition DTC, I'm having trouble filling the secondary air system monitor.
Unfortunately, I have to go to a...
So I have a smog test due on Monday and I'm having no luck figuring out what the issue is. My car is running fine, but the MIL/SES/CEL is on and giving me two codes; P0041, and P1412.
Things I've done:
Inspected the Secondary Air Injection System, and tested it. It all works perfectly. No...
I was wondering what kind of reader would let me read the specific BMW codes. I have a generic OBDII scanner that shows me all the regular stuff, but I would like to be able to read the more detailed things like suspension sensor faults, etc.
I have searched on the forums like crazy but can't...
Pulled the following four (4) codes from my '06 325 yesterday:
P-0597 Cruise control Circuit Open (x2) (listed as 1 and 4)
P-3026 Fuel and Air Metering and Auxiliary Emission Control
P-2243 O2 Sensor Bank 1 Sensor 1 Reference Voltage Circuit Open
Engine is running fine even under heavy load...
I am contemplating on writing a small utility software for logging carsoft readouts, thus enabling people to plot those data points later with excel/gnuplot/etc. Some people with fancier equipments have been able to post curves similar on this forum, drawing envious looks from their fellows...