BimmerFest BMW Forum banner
p0102
1-11 of 11 Results
  1. E60 / E61 (2004 - 2010)
    So my car has been stalling when it idles. I finally ran codes today and got back P0102 Mass or Volume Air Flow Circuit Low Input. I noticed my MAF is chipped on the top where the wires connect to it. Could my MAF be the cause of all of this, and just need to be replaced? If not what else could...
  2. E46 (1999 - 2006)
    For a few months now the cruise control hasn't worked in my 2004 330Ci, I've used a code scanner and it's given a P0102. I tried resetting it and driving for a few days and the code came back. I've attempted to clean the MAF as well to no change so I've concluded it must be dead. I'm looking at...
  3. E39 (1997 - 2003)
    I recently replace my passenger side valve cover gasket. At first the gasket didnt seal properly and was pouring oil out the bottom. I reseated the gasket but now i am have trouble starting my car, it cant idle it dies under 1000 rpm. I am not a 100 % sure i hooked up the spark plugs to the...
  4. E60 / E61 (2004 - 2010)
    So I recently did some work on my beamer (n52 engine). I had to fix an oil leak and replace the crankshaft position sensor. As many of you know that sensor is a S.O.B and you must remove a lot of stuff to get to it. So along the way replaced any gasket that I came across and a couple of...
  5. E39 (1997 - 2003)
    Hey guys, I recently finished doing the timing chain guides on my 1999 540i/6 and all was well. The engine runs really smooth and had no check engine lights. A few days after finishing the job, I turned the car on to move it up my driveway and noticed the CEL was on and there was some white...
  6. 7 Series - E38 (1995 - 2001)
    i recently bought a 2001 740il with 167k! it has all of the service records and was well maintained by the dealer up to 138k. The car runs and drives great! , no smoke on start up or freeway speeds. intake and valve gaskets replaced @ 115k by dealer.the car has been sitting for 6mo new correct...
  7. E46 (1999 - 2006)
    I had mycodes scanned and came to the conclusion to replace spark plugs, new maf sensor, new intake cps, and cleaned the disa valve. Its running worse now and I have coes: p1345, p1353, p1349, p0313, p0300, p0102, p0340, p0171. So alot of misfire. And still have the same code for the intake cps...
  8. E46 (1999 - 2006)
    First let me say that i looked all over the internet for this problem and i found alot of people having this problem but no one seemed like they had a fix for it! I have DTC P0102 Mass Airflow low input what could cause this problem i have everything stock and there are no mods the code was set...
  9. E46 (1999 - 2006)
    I am trying to resolve some DTCs on a 2003 325i w/158K miles. I received the following error codes off a $20 scanner: P0313 - Misfire Detected - Low Fuel Level P0128 - Coolant Temp Below Thermostat Regulating Temp P1349 - ??? P0102 - MAF or VAF A Circuit Low Input P0313 (Pending) The CD that...
  10. E46 (1999 - 2006)
    I posted earlier today, but was a reply to a thread, so here is a new thread on this. My 01 E-46 with new head gasket runs great, but turned on the MIL (service engine soon light) and has code P0102, Low voltage at Mass or volume Air flow sensor. I checked all the hose clamps they are tight...
  11. E39 (1997 - 2003)
    So earlier today i posted about my failed expansion tank, after only 6 months of use. WELL after i installed the new tank, i went for a drive. Car was running fine, barring a request to top off coolant (still working out the air bubbles). Suddenly, during acceleration from a stoplight, a...
1-11 of 11 Results
Top