BimmerFest BMW Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey fellas, first post. I'm not new to BMW but this is a new problem. My wiper linkage broke. How do I remove it? I just don't see how to remove the wiper arms or anything. Any help is appreciated.
 

· catso
Joined
·
3,181 Posts
First you should buy yourself a Bentley Service Manual. The wiper arms are held on by retaining nuts that are under the hinged cover at the pivot point. The linkage is accessible from the engine compartment by removing the rubber firewall cover which is held on by six screws. Make sure you mark the relative positions of everything in the linkage you remove so it will be aligned properly on reassembly.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top