Hi all, Merry Christmas!

After much research on this forum and the internet in general, I've finally done with my X4 V1 installation. I see there's not much documentations about the X4 <-> V1 install in particular, I am including pictures in case others want to do the same.

Thanks to fondoo1287 for the wiring diagram here: http://www.bimmerfest.com/forums/showthread.php?t=849220

I use the V1 original hardwired module with accessory port, and is going to install the CD. Just still trying to figure out where to put that. My thought now is to install the CD around the bottom of the gauge panel. Any thoughts?

Below are my install of the V1, hope you guys like it!