Joined
·
2 Posts
So my E92 335i 6MT has about 120k miles on it now. Its basically all stock except for a few small upgrades.
Related to shifting area, i have:
- 335iS motor mounts
- E46 M3 Trans. Mounts
- BMS CDV
Mys shifter bottom line is sloppy. i have some side to side play & front to back play in/out of gear. Shifting is fine, just not as precise as i want it.
So basically i want to upgrade every part of this.
So i was thinking:
-OEM BMW ZHP Weighted Shift Knob
-UUC EVO3 Short Shift Kit or OEM SSK Arm in place fo stock arm
-UUC DSSR - gear selector rod
-ECS Tuning Teflon Shifter Bushings - Oval?
All NEW OEM Bushings, pins, hardware, misc parts..
A question i had was do i still need the ECS Tuning Teflon Oval Shift Bushings if i'm going with a UUC SSK & UUC DSSR?
While im in there:
NEW OEM BMW UPDATED Aluminum/Rubber Guibo "Flex" Disc
New OEM Driveshaft Center Support Assembly
My question is what are you thoughts/feedback on the mods i have plnned? What can i do, that maybe you've done to improve upon this even further. Maybe you would go with a totally different setup or different brand parts? let me know!! Also how about the question of needing the oval teflon shifter bushings with a full UUC ssk/dssr kit. Anything else i should check/replace while i'm in there...??
Anthony
Related to shifting area, i have:
- 335iS motor mounts
- E46 M3 Trans. Mounts
- BMS CDV
Mys shifter bottom line is sloppy. i have some side to side play & front to back play in/out of gear. Shifting is fine, just not as precise as i want it.
So basically i want to upgrade every part of this.
So i was thinking:
-OEM BMW ZHP Weighted Shift Knob
-UUC EVO3 Short Shift Kit or OEM SSK Arm in place fo stock arm
-UUC DSSR - gear selector rod
-ECS Tuning Teflon Shifter Bushings - Oval?
All NEW OEM Bushings, pins, hardware, misc parts..
A question i had was do i still need the ECS Tuning Teflon Oval Shift Bushings if i'm going with a UUC SSK & UUC DSSR?
While im in there:
NEW OEM BMW UPDATED Aluminum/Rubber Guibo "Flex" Disc
New OEM Driveshaft Center Support Assembly
My question is what are you thoughts/feedback on the mods i have plnned? What can i do, that maybe you've done to improve upon this even further. Maybe you would go with a totally different setup or different brand parts? let me know!! Also how about the question of needing the oval teflon shifter bushings with a full UUC ssk/dssr kit. Anything else i should check/replace while i'm in there...??
Anthony
