BimmerFest BMW Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi Guys,

So i installed my led ramp today and i did not know that my bmw F31 2019 used can bus system for the high beam so i could not "steal" any 12V for the relay.

So i have been searching around the internet to find some info on HI and LO cables for the correct bus and im not 100% sure but the module i bought says it should be connected to the orange/green and green cable and these should be located in the middle of the FEM (white plug) and im assuming its the small connector am i right? i want to be 100% sure before i start connecting cables.

Thanks!

Font Material property Rectangle Screenshot Parallel
Electrical wiring Technology Cable Audio equipment Font
 
1 - 1 of 1 Posts
Top