Did you try default coding the module with NCS Expert?

 

I haven't and how would I got about that?

 

Since you have winkfp, you would probably have ncs expert?

I can't remember the exact procedure as it's been a long time since I've used it but there's plenty of videos and tutorials on how to use it. There's may even be a write up on this forum if you do a search.

 

Since you have winkfp, you would probably have ncs expert?

I can't remember the exact procedure as it's been a long time since I've used it but there's plenty of videos and tutorials on how to use it. There's may even be a write up on this forum if you do a search.

I think I did it. I followed this video and was able to program it with NCS Expert. Most of the error codes are gone except 93BB. I tried to see if I could factory program the DME and IHKA because I've had errors for those too but it either did it quickly or didn't work. The DME code is gone so that's neat. I tried ISTA to see the details of the error 93BB and it says "Implausible measured values". I wonder if it's the mat emulator is causing this or the seat belt buckle is no good?

 

What was the error code before flashing? The same one? Looks like the update didn't help....
measure and check.

 

What was the error code before flashing? The same one? Looks like the update didn't help....
measure and check.

Already figured out the problem. It was the mat emulator kit. More specifically one that connects to the seat belt buckle. The mat emulator itself works fine but the seat belt buckle didn't. I measure it's resistance to be 550Ohms, but I have no idea what resistor it needs to be? For now I just keep the seat belt buckled, even without a passenger.