BimmerFest BMW Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
250 Posts
Discussion Starter · #1 ·
i wasn't too impressed with the retail price of the under bumper liners so i decided to make my own,
perhaps if i was only going to purchase them once i might pay but i was fairly confident that at some point in the cars future someone may drive it into a parking stop etc.

i simply used some cardboard to mark out the area then traced onto some ripple finished aluminium

each side had to be made in 2 parts as you can't fold on a curved section,

i pop riveted the two sections together then covered liberally with underbody tar before fitting

it took a bit of effort to line everything up but the end results i feel are worth it, especially compared to $500AU


end result = happiness
 

Attachments

1 - 2 of 2 Posts
Top