BimmerFest BMW Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello Everyone,

I am new here and I hope that I am doing this right?

I needed to replace my battery in my 2000 Mcoupe and then I've noticed that I now needed to enter my radio code.

I found the serial number by holding the "M" button for a few seconds and I then gave the serial number to a dealer who gave me the code.

After I entered the code, the five lines (-----) are now blinking (apposed to them staying steady after entering the wrong code).

My book says to press the > button but the five lines (-----) keep blinking after I do this. Is there a step that I am missing?
 

·
Registered
Joined
·
56 Posts
You locked it. If you fail to enter the code after your 5th attemp it locks. You have to have the unit on for an hour. After that you can try the code again.
 
1 - 4 of 4 Posts
Top