G30 No communication with FlexRay modules after coding.

dominikmazurowski · Jan 19, 2024

Hi,
I was coding EU radio frequencies to my US spec M550i, by mistake I pressed 'code' instead of 'code FDL' in Esys. After a few days, I realized that ISTA won't connect with modules connected via the FlexRey bus.
I saw a few posts about this issue, but unfortunately, I lost a copy of the SVT file backup.
Could someone guide me what is the procedure to fix it? I'm attaching a few photos from Esys.

I saw this thread, but I'm not sure if the described procedure by @@shawnsheridan will help.

Siki78 · Jan 19, 2024

Write svt back to vcm. If you doesn`t know how to write me pm I can do it over teamviewer

Jorbabcnman · Jan 19, 2024

Would you be so kind as to give the explanations here? The solution could be useful to more people if you are so kind, thank you.

TheNine90 · Jan 19, 2024

No need for battery charger,
Calculate svt taget. Load it in VCM section. Write SVT target to vcm

Siki78 · Jan 19, 2024

Like TheNine90 said
1. Go to "Coding" mask, in the right tab: select "full calculation", choose correct i-Step shippment and i-Step target.
2. Then press "Calculate SVT"
3. Save calculated SVT as "target.xml"
4. Go to "VCM" mark
5. Choose saved on step 3 file as "SVT target"
6. Go to "Master" tab, press "Write SVT"
7. Go to "Backup" tab, press "Backup data"
8. Reboot car
Enjoy

dominikmazurowski · Jan 19, 2024

Thank you so much. Problem is solved.

Siki78 · Jan 19, 2024

dominikmazurowski said:
Thank you so much. Problem is solved.

You are welcome

Siki78 · Mar 25, 2024

Should to start immediately

G30 No communication with FlexRay modules after coding.

Our Vendors

Top Contributors this Month

Recommended Communities