BimmerFest BMW Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
'01 Coupe (Non M)

Got the car back from the body shop after having been rear-ended and noticed they put the wrong handle on the outside of the rear hatch. They put the handle from a '99 instead of the chrome one used on the '01. To make a long story short (if not too late) I now have the correct handle which I am going to install (my choice) but don't know which gasket is the correct one.

Looking at item#11 in the attached pic, can someone tell me which of the two part numbers listed would be the correct one?
 

Attachments

· 19,585 Miles
Joined
·
11,211 Posts
Uj2 said:
'01 Coupe (Non M)

Got the car back from the body shop after having been rear-ended and noticed they put the wrong handle on the outside of the rear hatch. They put the handle from a '99 instead of the chrome one used on the '01. To make a long story short (if not too late) I now have the correct handle which I am going to install (my choice) but don't know which gasket is the correct one.

Looking at item#11 in the attached pic, can someone tell me which of the two part numbers listed would be the correct one?
The 400 one. I assume retrofit kit 51 22 8 400 128 comes with one.

If you look it up under a Z3-2.8 it shows the one you don't want. It also shows the retrofit kit on the next diagram.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top