BimmerFest BMW Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Long story short my transfer case on a 2011 535i x-drive was grinding and started locking up so I got a transfer case from a 2011 550i GT x-drive and swapped it. I'm still getting the x-drive stabilization lights so I assume I need to code it/activate it properly. Any help would be greatly appreciated as I'm staranded with one car between me and my wife until I can get my bimmer rolling!

I ordered INPA Rheingold and a cable. And can get other software if needed.

Thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top