Bimmerfest BMW banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1 (Edited)
Hi. I'm getting the codes
p0600 serial communication link,
p0031 HO2S heater control circuit low bank 1 sensor 1
p0051 HO2S heater control circuit low bank 2 sensor 1

and my transmission is currently in limp mode every time i start the car.
i was wondering if anybody can confirm that faulty oxygen sensors or the wiring can cause the p0600 and whether that can also cause a transmission limp mode?

Does this warrant a replacement of these oxygen sensors? I'm still relatively new to working on cars
I'll be going out soon to buy a multimeter to check the wiring, just wondering if anybody has any experience with these cars and can give me some pointers?

Thanks, Victor

 

·
Registered
Joined
·
15,512 Posts

These are not related to P0600 P0600 Serial Communication Link DTC
 
1 - 2 of 2 Posts
Top