BimmerFest BMW Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
431 Posts
Ask your dealer....

Dealers like Momentum utilize 3rd parties who tint customer cars. When I lived in Houston, I did just that. Momentum uses a shop literally right around the corner from them. They service the Infiniti and Acura dealer near Momentum.

Get their number and call them directly. They should cut you a good deal.

Robert
 

· Registered
2015 335 M-Sport Mineral Gray
Joined
·
6,523 Posts
y
Rgol said:
Dealers like Momentum utilize 3rd parties who tint customer cars. When I lived in Houston, I did just that. Momentum uses a shop literally right around the corner from them. They service the Infiniti and Acura dealer near Momentum.

Get their number and call them directly. They should cut you a good deal.

Robert
The tint shop that Momentum uses is called Momentum Tint. The same person owns FormulaOne Tint at 5741-A Westheimer, a little west of the Galleria. When I was shopping for tint I had their price list which varied depending on the specific line of FormulaOne tint you wanted but unfortunately have tossed it. If there is a concern about reception and interference then the film to use is a ceramic type. FormulaOne's version is called Pinnacle and it is $500.

I had Huper Optik Ceramic installed for $399 at Executive Motoring Boutique at 2823 Hillcroft St, half a block south of Westheimer. They claim to do the MB dealerships.

Both films have been discussed at lenght here in BF. Do a search an you will find a lot of information.
 

· Registered
Joined
·
61 Posts
Discussion Starter · #4 ·
Just got mine done with the Huper Optick Ceramic 30 all the way around (Executive Boutique on Gessner). Kinda rainy, so my car is wet in the below pictures. Makes everything a bit more shiny. Here a few pics...

Thanks to everyone for the help. AM works just like it did before. As you can see, my XM is on the top of the car, so no problem there.

;)
 

Attachments

· Registered
2015 335 M-Sport Mineral Gray
Joined
·
6,523 Posts
natotx said:
Just got mine done with the Huper Optick Ceramic 30 all the way around (Executive Boutique on Gessner). Kinda rainy, so my car is wet in the below pictures. Makes everything a bit more shiny. Here a few pics...

Thanks to everyone for the help. AM works just like it did before. As you can see, my XM is on the top of the car, so no problem there.

;)
Looking good. :thumbup:

A suggestion to make sure the film attaches correctly where you have dot matrix. For next couple of days using a soft cloth press the film against the dot matrix. Do NOT rub the film.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top