BimmerFest BMW Forum banner
1 - 6 of 6 Posts

· into things retro
Joined
·
4,777 Posts
Discussion Starter · #1 ·
I was at the Simpson World down in Torrance yesterday checking out helmets for AutoXing and they have some of their older ones on clearance in the back room.

They are S or M 95 (which is okay for LA BMW CCA AutoX) but depending on which model you would be looking for, they may only have some of the smaller sizes left. In you don't have a helmet yet and are in the area, worth a checkout. They also have gloves, shoes, and seatbelt shoulder pads.
 

· into things retro
Joined
·
4,777 Posts
Discussion Starter · #3 ·
Directions to Simpson

Take the 110 South past the 405 (or south from the 405) and exit on 223rd St. going right or West until you get to Normandie. Make a left (South) on Normandie and it's a few blocks down on the left. I think they are open at 9:00.
 

· Registered
Joined
·
3,907 Posts
Re: Directions to Simpson

Thanks Scott! :thumbup: I have been thinking about a pair of cheap gloves though.

scottn2retro said:
Take the 110 South past the 405 (or south from the 405) and exit on 223rd St. going right or West until you get to Normandie. Make a left (South) on Normandie and it's a few blocks down on the left. I think they are open at 9:00.
 

· into things retro
Joined
·
4,777 Posts
Discussion Starter · #5 ·
For AutoX . . .

I think I'm going to get a pair of their 'Wrenchers' gloves for about $20. They're not too bulky and have good grip.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top