BimmerFest BMW Forum banner
1 - 10 of 10 Posts

· Bimmer Lover Since '96
Joined
·
155 Posts
Discussion Starter · #1 ·
Our newly purchased '01 325xi still has the paper temporary license tags stuck on there with adhesive tape.

What screw sizes will I need for the front plate (4 places) & the rear plate (4 places)?

Thanks!
 

· The Boss of Nobody
Joined
·
3,737 Posts
Our newly purchased '01 325xi still has the paper temporary license tags stuck on there with adhesive tape.

What screw sizes will I need for the front plate (4 places) & the rear plate (4 places)?

Thanks!
Sorry I don't remember the size, but I took the entire front plate trim with me into Home Depot and matched the size there. I wanted stainless so it wouldn't rust in place. I believe places like AutoZone actually sell these fasteners as well. Good luck.
 

· Super Moderator
Joined
·
20,971 Posts
5 mm x 12 mm. 5 is the diameter and 12 is the length. That is for the back.
Our state does not require a front plate.
Yeah I was going to say M5 or M6...
 

· The Boss of Nobody
Joined
·
3,737 Posts
There is also a replacment trim piece you can buy to delete the front plate holder if it's not required in your state.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top