Limp mode after coding NCSexpert

2523 Views 3 Replies 3 Participants Last post by Ilebozinoski, Jan 26, 2022

bi

Discussion Starter · Dec 25, 2017 (Edited)

Hi all,

I was trying to retrofit the cruise control in my e70. I have added VO 544 and fa write CAS and FRM. Then coded each modules. The EHB3 is the only module that throw an error message but I recoded it again and worked fine.

When I drive the car the screen says 'faulty in drive'. The car is stuck in 3rdt gear and won't shift anymore. This all started after coding via ncsexpert.

I check the error code in inpa and the EGS has the CF33 error. I followed this guide http://wiki.bavariantechnic.com/index.php?title=Transmission_Fault_Code_CF33 but still no luck.

https://ibb.co/hcnRUm

Appreciate any response

See less See more

Save

Reactions: 1

1 - 2 of 4 Posts

bi

Discussion Starter · #2 · Dec 25, 2017

Problem solved. I clear the adaptation using ISTA-D. Waited around 30-secs until the car goes into sleep. Deleted the error while the car is off.

Car is back to life. I didn't know that there are errors that should be deleted while car is off. I always thought that ignition has to be turned on.

Save

Reactions: 1

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month