BimmerFest BMW Forum banner
1 - 3 of 3 Posts

· #422323
Joined
·
2,325 Posts
good job.

I propose to merge this, with the other CCV thread, as there are many good advices in that thread.

Like the OP, my CCV was not leaking but it was good to get that out of the way.

Also for future seekers, I would like to link this thread too: http://forum.e46fanatics.com/showthread.php?t=555847&highlight=ccv

it has some good pics too.
 

· #422323
Joined
·
2,325 Posts
I had to do this DIY for the second time, and I found it to be a little easier the second time around.

I think it would be much easier if one did the oil separator DIY and the oil housing gasket at the same time. This would give both repairs plenty of room.

I don't know if this has been mentioned but putting the power steering reservoir to the side gives you more room to assemble to oil separator hoses.


.


I referred to this thread a few times even though I had done this repair before. Thanks to all who contributed, especially OP.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top