BimmerFest BMW Forum banner
1 - 1 of 1 Posts

· Registered
8 Posts
Discussion Starter · #1 ·
On a 1995 325is how hard is it to replace the molding around the dripwell above the windows? Does it just snap on? What about the rubber weatherstripping under the rear windows? Can the narrow thick molding on the doors (and fenders) be replaced with the wide short moldings of the M3? And lastly does anyone have a good mailorder source for factory replacement parts such as these?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.