BimmerFest BMW Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
HI,

i have retrofited comfort seats from an E70 from England into a E70 US version

i have coded with NCS $453 $456 $494 but my problem now is:

the seats dosen't move from the switches only with the ISTA via TRIGER COMPONENT

also are inversed left with the right, i have double checked the wires and are ok.

i don't know what else to do next :dunno:

Any help apreciated

Thank's
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #2 · (Edited)
HI,

i have retrofited comfort seats from an E70 from England into a E70 US version

i have coded with NCS $453 $456 $494 but my problem now is:

the seats dosen't move from the switches only with the ISTA via TRIGER COMPONENT

also are inversed left with the right, i have double checked the wires and are ok.

i don't know what else to do next :dunno:

Any help apreciated

Thank's
problem found.8 pin black conector from the seat modul.

the pasager conector must have the pin number 2 to the ground. and from the driver seeat must be cuted.(only if the donor car is from a country with right handle)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top