BimmerFest BMW Forum banner
1 - 1 of 1 Posts

·
.
Joined
·
358 Posts
Can't comment on whether they're the same or not. But I would toss out.. there are two pins / releases that snap on to the back of the roll hoop console area. The posts are on the car. The snaps are on the boot cover. Here's the thing though. Don't try to push them on. You'll break 'em. The snaps have a ball on the end. Pull it back to release the mechanism inside.

So.. to put the snaps on the posts, pull the little ball back and just slide them over the post. There isn't actually any snap feel or sound to it. Release the ball and they won't come off ('til you pull the ball again).

There's another set of these on the outside wings of the boot cover.

Everything else about the boot cover... it just tucks in underneath the rubber seal around the trunk.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top