BimmerFest BMW Forum banner

Roundel Wheel Logo Installation

985 Views 4 Replies 3 Participants Last post by  vern
Hey Folks,

Just received new Roundel Logos for my wheels. Do the old ones just pop out? Plus, the new ones didnt come with an adhesive backing. What kind of glue or adhesive would I use to make sure the new ones stick properly? Thanks for the help.
1 - 5 of 5 Posts
For OEM wheels, the center piece just pops right out from the back. I used the large end of a screwdriver.

As for glue? Maybe superglue? I thought they were stickers. =)

BTW, I had to buy a set of the plastic roundel thingies (the entire pop-out assembly w/ the roundel on it) and they were only like $15. Did you look into that?

Thanks webguy330i. Where did you buy the whole logo plus the plastic thing from? I didnt know you could do that.
I believe it was ... 99% on that. =)

Any BMW dealership should stock them.
Try circle bmw they are closer to you .you can pick them up if you would want to.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.