BimmerFest BMW Forum banner
1 - 5 of 122 Posts

· Registered
Joined
·
2,100 Posts
I have both gray outer and inner covers for sale if interested. There in new condition and actually the passenger side was replaced new under warranty just before the warranty expired not long ago.
 

· Registered
Joined
·
2,100 Posts
I'm confused.

The REALOEM site seems to show both BMW E39 seat covers (passenger and driver) are the same part number (i.e., 52107058009, $39.62) ...

Yet the Maxmillian site seems to show the two covers as different part numbers - where the driver side being BMW part number 52108207249 & the passenger side being BMW part number 52108207250 (both $39.39 each) - yet - the driver side (which I need) says "ENDED" (which I presume to mean you can't get it).









*******> ********>
I don't get it.

Is the passenger side "outer cover" the same part as the driver side (I need the driver's side) or different? I don't mind replacing both the driver and passenger side outer covers as they're all scratched up ... but it would be nice to be able to figure this out ahead of time.
There sold as a pair so the drivers side outer cover and passenger side outer cover is one part # even though they are different parts and are not interchangable. I think they used to sell them individually some time ago but not anymore. I can only assume this other company is selling them as seperate pieces based on what you said. I have both outer and both inner pieces if you need them.
 

· Registered
Joined
·
2,100 Posts
I'm 99% sure all connectors can only go on one way. Even if you broke a tab it still should only come togther one way. Don't force anything. Look at the the pins closely and or wire colors and match it up.
 

· Registered
Joined
·
2,100 Posts
Wow this thread is still going. Bluebee your sure putting some serious effort here. On the front seat backs they are held on by two screws at the bottom while the top portion has has a clip that slides up under and inside the seat. Therefore remove the 2 screws at the bottom and pull out slightly and slide it down and out. If you tilt your front seat all the way up and tilt it down, then get on your knees and look up under the seat closely for the 2 screws. You may have to pull some seating out of the way to find them.

OK are we done now?
 
1 - 5 of 122 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top