BimmerFest BMW Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I just replaced my output pulse generator, put it back together and my Bavarian Technic code reader threw me these codes now after in went into limp mode! I have yet to fill it up properly by running through the gears, getting it up to temperature and topping it off. Am I making this a bigger deal than it is?

I also have these codes and would like some help or suggestions to fix them

code 54: valve inlet from left
code 14: auxiliary water pump
code 141: ATS signal telegram error or no telegram

Code 54 I have no clue
Code 14 just needs to be replaced?
Code 141 is a simple busted bulb?

Any and all help would be appreciated :thumbup::dunno:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top