Voltage must be 8.4-8.5V
Yes you need to code fdl to apix1


Sent from my iPhone using Tapatalk

 

Is that all I need to code fdl to apix1?

 

Yes. Apix1 and color depth i think to 18
But don’t forget that apix1 screen will work correctly only if your headunt has 18.03 software or older. Newer software doesn’t support apix1 screen


Sent from my iPhone using Tapatalk

 

Thanks! I can downgrade to 18.03 right?

 

Yes


Sent from my iPhone using Tapatalk

 

Still showing no signal after changing FDL to APIX1, SPI and colour depth to 18. Voltage is stable and nothing else has been changed.

 

Won't it cod if voltage was higher than that ?

Sent from my SM-A805F using Tapatalk

 

Doesnt work if voltage is a 9v

 

Voltage to 8.42V
Apixmode = APIX1
Color Depth = 18
Com Mode = spi
i-Level = 18-03

also check CID_DISPLAY_REZ and CID_DISPLAY_SIZE for correct display settings. If evo came pre-coded, seller might have set evo to large screen size.
CID will work with higher ilevel but will randomly stay black or say "no signal" after locking the car. If you reboot headunit by pressing powerbutton for 45s and screen still doesn´t work, coding or voltage is not correct.

if everything is correct, it might also be an issue with the Voltage regulator. get an multimeter and measure the output voltage of the voltage regulator. these one with an voltage display often show incorrect values.

 

Tried all this can someone remote over and give me a hand I'm using bimmercode which might not be enough

 

FYI I sliced my current purple connector LVDS switched over the wires. Blue to green. Orange to brown and flipped the side pins as power as ground are flipped for APIX2

 

well.... you shouldn´t have changed the pinout of your LVDS cable. NBT (APIX1) and NBT Evo (APIX2) use the same cable. wire colors might be different but pin assignment is the same

 

My current screen is a 6.5 inch CID screen. It's from the Entrynav1 I was told the pinout was different

 

it will never work with small screen, u need one from nbt or nbt evo

 

So I need a Pro Nav 8.8 inch minimum?

 

What??? You trying with 6.5 screen??


Sent from my iPhone using Tapatalk

 

Yep

 

No chance mate. Need to buy 8.8 screen…


Sent from my iPhone using Tapatalk

 

If I buy new 8.8 screen can I still use my entrynav1 lvds cable?

 

You need cable from professional navi, or you can cut old wire and change some pinout


Sent from my iPhone using Tapatalk

 

Do you have the pinout can't seem to find it anywhere?

 

As far as i know 6.5 e1 screens don’t works with evo units. Only entrynav units.