BimmerFest BMW Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Hi,
since I'm new here, I'd like to thank all of you for providing information how to code my F10. I already tuned my F10 based on the F10_CheatSheet_V3.0 and currently I'd like to set up the welcome lights. I enabled License Plate Lights, Fog Light and Position Lights, but when I unlock the car only the lights in the door knobs are on.

Is there anything else I have to do, that the other lights are already enabled?

many thanks in advance for any hint and best regards
Michael

PS: WL_Timeout is set to 14 (default) and of course I checked the welcome light box in iDrive
 

· Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
OK, reading the manual again I found out that the light switch has to be in position "automatic headlamp control" or "low beams".
Is it possible to code it to enable welcome light if the light switch is set to "lamps off"?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top