[IMG=100x100]http://i.imgur.com/x6A9cXy.jpg[/IMG]

This is the inital warning

 

And this is the error I get once I proceed into the check/warning.

 

Check your struts and shocks

 

Hey guys,
unsure if anyone else is interested but i'll update anyway.
Turns out it's a faulty module. BMW independent faulted this for me close to no time at all. Purchasing a replacement module via eBay and will post another update once it's installed and operational.


Also, sorry about those images being huge, i posted that from my mobile.

Thanks.

 

Hi team!
So I need some help trying to get to the EDC controller.

I've spent about 3 hours on trying to get to it but cannot.

How can I get to it? I'm struggling to remove the Glovebox itself and this is an image i found but i just can't seem to figure it out.

Could someone help and shed some light please?

 

Hey team,

so i've managed to remove the glove box finally, that was a small mission but none the less done.
HOWEVER, I don't want to remove all the dash trim. So, is someone able to tell me how to release this cable?

I can almost pull the unit out but this cable pushes up against the rear of the fuses preventing me from pulling it further and after about 30mins of trying to figure this plug, i've come to ask for help.

Please.

 

Pull out the tab (top right of the visible part of the circled connector), and the plug will release itself. When you reconnect the plug, push the tab back in to lock it in place.

 

I can push it inwards. (to the left) but it kinda moves a wee bit maybe 1mm or 2mm but then stops and I can't pull any further.
Do I pull the tab top right to the right or left?
Thank you for the response!

 

Pull it to the right, it should come out about 10mm or so and release the plug at the same time. They can be tough sometimes.

PS you'll probably have to program the replacement module.

 

Sweet. I'll give that a go tomorrow.
Joe from EuroSrugeon (Penrose, Auckland) mentioned that.
Happiest news hearing my EDC fault was just the module haha

 

Also, would you think it was safe to drive with the glove box disconnected open\exposed?

 

Completely safe.

 

Thanks! I got a replacement unit and literally trying to install it now.

 

ALL SORTED.

So, I installed the replacement EDC module and it didn't even needed registering with my car. Fired the car up. No alerts, no faults and no checks.
Now I just need to test it all out. Anyone know how to test?

Thanks guys.